GMOS-LAN-03 - Sonic Electronix

Copy and paste this link to your website, so they can see this document directly without any plugins.



Keywords

wire, Connect, aftermarket, radio, GMOS-LAN-03, harness, speaker, radio., volume, will, OnStar, with, radio’s, instructions, negative, front, 16-pin, that, left, Black/Yellow, This, positive, output, right, rear, output., battery, Onstar, wire., installation

Transcript

METRA. THE WORLD’S BEST KITS.™
© COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION
1-800-221-0932 metraonline.com
INSTALLATION INSTRUCTIONS FOR PART INSTGMOS-LAN-03
RE
V.
1
2/
28
/1
1
Cutting Tool • Crimping Tool • Tape • Connectors (example: butt-connectors, bell caps, etc.
IGNITION
TERM
INALS
W
IRE
CUTTER
M
3.5
M
2.6
M
3
M
5
M
4
ISO
62.5
1.5
TOOLS REQUIRED
GM LAN 11 Non-amplified OnStar
Interface 2006-up
GMOS-LAN-03
GMOS-LAN-03 interface • 16-pin harness with stripped leads
18-pin harness to 30-pin GM harness with stripped leads
INTERFACE COMPONENTS
KIT FEATURES
APPLICATIONS
• Provides accessory (12-volt 10-amp)
• Retains R.A.P. (Retained Accessory Power)
• Used in non-amplified systems or when replacing amplified systems
• Retains chimes
• Provides NAV outputs (Parking Brake, Reverse, Mute, V.S.S.)
• ASWC harness included (ASWC not included)
• Retains OnStar/OE Bluetooth
• Adjustable volume for chimes and OnStar
• High level speaker input
• USB updatable
• Retains balance and fade
See inside front cover
Applications
GMOS-LAN-03
Caution
Metra recommends disconnecting the negative battery terminal before beginning any
installation. All accessories, switches, and especially air bag indicator lights must be
plugged in before reconnecting the battery or cycling the ignition.
*NOTE: Refer also to the instructions included with the aftermarket radio.
CHEVROLET
Cobalt 2007-2010
HHR 2006-up
Malibu 2008-up
PONTIAC
G5 2007-2008
G6 2009
Solstice 2006-2009
SATURN
Aura 2006-2009
Sky 2006-2009
(Note: This interface will also work in vehicles listed below that are not equipped with OnStar)
From the 16-pin harness:
• Connect the Red wire to the ignition wire of the aftermarket radio
• Connect the Orange/White wire to the illumination wire of the aftermarket radio. If the
aftermarket radio has no illumination wire just tape off the Orange/White wire.
• Connect the White wire to the left front positive speaker output of the aftermarket radio
• Connect the White/Black wire to the left front negative speaker output of the
aftermarket radio
• Connect the Gray wire to the right front positive speaker output of the aftermarket radio
• Connect the Gray/Black wire to the right front negative speaker output of the
aftermarket radio
• Connect the Brown wire to the mute wire of the aftermarket radio. If the aftermarket
radio does not have a Mute wire, tape up the Brown wire.
• Connect the Light Green wire to the parking brake wire of the aftermarket
navigation radio.
• Connect the Blue/Pink wire to the VSS or speed sense wire of the aftermarket
navigation radio.
• Connect the Green/Purple wire to the reverse wire of the aftermarket navigation radio.
• Plug the 16-pin harness into the GMOS-LAN-03
3
Connections to be made
GMOS-LAN-03
4
GMOS-LAN-03
From the 30-pin harness:
• Connect the Yellow wire to the radio’s 12-volt battery or memory wire.
• Connect the Black wire to the radio’s ground wire.
• Connect the Blue wire to the antenna turn on wire of the aftermarket radio.
• Connect the Green wire to the radio’s left rear positive speaker output.
• Connect the Green/Black wire to the radio’s left rear negative speaker output.
• Connect the Purple wire to the radio’s right rear positive speaker output.
• Connect the Purple/Black wire to the radio’s right rear negative speaker output.
• Plug the 18-pin harness into the GMOS-LAN-03
• The Black/Yellow wire is for the OnStar volume adjustment. This will be discussed in
the OnStar Level Adjustment section of this instruction.
The 12 pin harness (ASWC plug) will be discussed later in the manual.
Installing the GMOS-LAN-03
• With all connections completed to the aftermarket radio, plug the 30-pin harnesses into
the vehicles wiring harnesses.
• Reconnect the negative battery terminal.
• Cycle the key, by turning the ignition on for 30-seconds. Then off and on
again to test the radio.
Connections to be made
5
GMOS-LAN-03
1) Turn the ignition on if not already, and then turn the radio on to verify that the radio
works. Check balance and fader controls for proper operation.
2) Push the Onstar button (if equipped) to verify Onstar is working. The radio will shut off or
mute, depending if the Brown wire on the 16-pin harness is connected, and Onstar will
be heard through the front speakers. Turn off Onstar and the radio will turn back on.
Chime Volume Adjustment
To adjust the chime volume, use a small
screwdriver to rotate the potentiometer
clockwise to make the chime louder and
counterclockwise to make it softer. The
potentiometer is located on 16-pin side
of the GMOS-LAN-03.
OnStar Level Adjustment
To adjust the OnStar volume level find the
Black/Yellow wire on the 14-pin harness.
Push the blue OnStar button, while the
voice is speaking tap the Black/Yellow wire to ground. There are 4 volume settings for
OnStar; once the 4th setting is reached and the Black/Yellow wire is tapped to ground it
will automatically go back to the first volume setting. Once the volume is set it will stay at
that volume until the Black/Yellow wire is tapped to ground again. This can be set during
installation and then left alone. If user adjustment is desired, the customer may also tap
volume up or down on the steering wheel (if equipped) to adjust the OnStar level.
Additional 12-pin harness (ASWC harness)
This 12-pin harness is to be used in conjunction with the ASWC (not included).
Please refer to ASWC instructions for programming.
Testing the GMOS-LAN-03
GMOS-LAN-03
6
Aftermarket radio and amplifier wiring
B
LK
RADIO
Y
EL
A
FT
ER
M
A
R
K
ET
R
A
D
IO
A
N
D
A
M
PL
IF
IE
R
W
IR
IN
G
S
P
-2
00
3
S
P
-2
00
3
O
P
TI
O
N
A
L
R
E
Q
U
IR
E
D
G
M
O
S
-L
A
N
-0
3
R
FR
F
LFLF
-+-+
C
H
IM
E
V
O
LU
M
E
A
D
JU
S
T
M
E
N
T
R
E
D
G
R
E
E
N
B
LU
E
/P
IN
K
B
LU
E
/W
H
IT
E
G
R
E
E
N
/P
U
R
P
LE
B
R
O
W
N
16 PIN
18 PIN
2
PI
N
RR
+ RR
-
LR
-
LR
+
G
M
3
0
PI
N
TO
A
FT
E
R
M
A
R
K
E
T
R
E
A
R
A
M
P
LI
FI
E
R
TO
A
FT
E
R
M
A
R
K
E
T
F
R
O
N
T
A
M
P
LI
FI
E
R
RFRFLFLF
-+-+
X X X X
B
LA
C
K
/Y
E
LL
O
W
B
LA
C
K
/W
H
IT
E
O
R
A
N
G
E
O
R
A
N
G
E
/W
H
IT
E
7
Notes
METRA. THE WORLD’S BEST KITS.™
© COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION
1-800-221-0932 metraonline.com
INSTALLATION INSTRUCTIONS FOR PART INSTGMOS-LAN-03
RE
V.
1
2/
28
/1
1
KNOWLEDGE IS POWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
IMPORTANT WARNING
This product includes instructions for installation which must be carefully
followed. The instructions are worded in such a manner to assume
that the installer is capable of completing these type of electronic
installations. If you are unclear as to what you are instructed to do or
believe that you do not understand the instructions so as to properly and
safely complete the installation you should consult a technician who
does have this knowledge and understanding.
Failure to follow these instructions carefully and to install the
interface as described could cause harm to the vehicle or to safety
systems on the vehicle. Interference with certain safety systems
could cause harm to persons as well. If you have any questions in
this regard please call the Help line or Metra at
1-800-221-0932 for assistance.

PDF Document reader online

This website is focused on providing document in readable format, online without need to install any type of software on your computer. If you are using thin client, or are not allowed to install document reader of particular type, this application may come in hand for you. Simply upload your document, and Docureader.top will transform it into readable format in a few seconds. Why choose Docureader.top?

  1. Unlimited sharing - you can upload document of any size. If we are able to convert it into readable format, you have it here - saved for later or immediate reading
  2. Cross-platform - no compromised when reading your document. We support most of modern browers without the need of installing any of external plugins. If your device can oper a browser - then you can read any document on it
  3. Simple uploading - no need to register. Just enter your email, title of document and select the file, we do the rest. Once the document is ready for you, you will receive automatic email from us.

Previous 10

Next 10