Meaning Of Characters - Subaru Online Parts

Copy and paste this link to your website, so they can see this document directly without any plugins.



Keywords

DIA., 5/16", FRONT, ALIGN, SPOILER, 25/64", PART, REAR, POINT, NUMBER, DECKLID, CORNER, E721SAJ000, THIS, EDGE, (8mm), PAGE, AMERICA, DATE, 09/23/2009, ISSUE, Remove, SUBARU, with, VEHICLE, ASSEMBLY, deck, 17/64", PUNCH, LOCATIONS

Transcript

PART NUMBER : E721SAJ000
KIT CONTENTS
DESCRIPTION : LEGACYINSTALLATION
INSTRUCTIONS
PART NUMBER
E721SAJ000
ISSUE
02
DATE
09/23/2009 SUBARU OF AMERICA
PAGE
1/5
A
TOOLS REQUIRED:
Meaning of Characters:
: Install : Connect
: Tightening Torque: Do Not Discard
4X 1X
7 mm
(17/64")
10 mm
(25/64")
RUST
PREVENTATIVE
MAGNET
10 mm
6"
REAR SPOILER ASSY
B
14 mm
(17/32")
C
E
1X
: Re use
: Remove : Location of
clip or screw
D
8 mm
(5/16")
1X Wire Tie
3 mm
(1/8")
5/16" (8 mm) DIA.
25/64" (10 mm) DIA.
25/64" (10 mm) DIA.
5/16" (8 mm) DIA.
5/16" (8 mm) DIA.
5/16" (8 mm) DIA.
5/16" (8 mm) DIA.
5/16" (8 mm) DIA.
5/16" (8mm) DIA.
5/16" (8mm) DIA.
ALIGN TO EDGE
ALIGN THIS POINT
TO FRONT
CORNER OF DECKLID
FRONT
FRONT
2010 LEGACY REAR SPOILER
PART # SOA???????
DEALER MARKING TEMPLATE
APPROXIMATE
CENTERLINE
OF VEHICLE ALIGN TO EDGE
NOTE: ALL HOLES TO BE MARKED AT
PUNCH LOCATIONS WITHIN THE
CLOUD SHOWN
ALIGN THIS POINT
TO FRONT
CORNER OF DECKLID
25/64" (10 mm) DIA.
17/32" (14 mm) DIA. LH ONLY
(HARNESS)
17/64" (7mm) DIA.
2
REAR SPOILER ASSEMBLY
PART NUMBER
E721SAJ000 SUBARU OF AMERICA
ISSUE
02
DATE
09/23/2009
PAGE
2/5
1
1 ) Remove trunk handle.
2 ) Remove deck lid carpet panel by removing 12 push pins.
12x
1 ) Secure mylar template with masking tape.
2 ) Mark drill hole locations with center punch.
TRUNK
HANDLE
1x 5/16" (8 mm) DIA.
25/64" (10 mm) DIA.
25/64" (10 mm) DIA.
5/16" (8 mm) DIA.
5/16" (8 mm) DIA.
5/16" (8 mm) DIA.
5/16" (8 mm) DIA.
5/16" (8 mm) DIA.
5/16" (8mm) DIA.
5/16" (8mm) DIA.
ALIGN TO EDGE
ALIGN THIS POINT
TO FRONT
CORNER OF DECKLID
FRONT
FRONT
2010 LEGACY REAR SPOILER
PART # SOA???????
DEALER MARKING TEMPLATE
APPROXIMATE
CENTERLINE
OF VEHICLE ALIGN TO EDGE
NOTE: ALL HOLES TO BE MARKED AT
PUNCH LOCATIONS WITHIN THE
CLOUD SHOWN
ALIGN THIS POINT
TO FRONT
CORNER OF DECKLID
25/64" (10 mm) DIA.
17/32" (14 mm) DIA. LH ONLY
(HARNESS)
17/64" (7mm) DIA.
5/16" (8 mm) DIA.
25/64" (10 mm) DIA.
25/64" (10 mm) DIA.
5/16" (8 mm) DIA.
5/16" (8 mm) DIA.
5/16" (8 mm) DIA.
5/16" (8 mm) DIA.
5/16" (8 mm) DIA.
5/16" (8mm) DIA.
5/16" (8mm) DIA.
ALIGN TO EDGE
ALIGN THIS POINT
TO FRONT
CORNER OF DECKLID
FRONT
FRONT
2010 LEGACY REAR SPOILER
PART # SOA???????
DEALER MARKING TEMPLATE
APPROXIMATE
CENTERLINE
OF VEHICLE
ALIGN TO EDGE
NOTE: ALL HOLES TO BE MARKED AT
PUNCH LOCATIONS WITHIN THE
CLOUD SHOWN
ALIGN THIS POINT
TO FRONT
CORNER OF DECKLID
25/64" (10 mm) DIA.
17/32" (14 mm) DIA. LH ONLY
(HARNESS)
17/64" (7mm) DIA.
4
REAR SPOILER ASSEMBLY
PART NUMBER
E721SAJ000 SUBARU OF AMERICA
ISSUE
02
DATE
09/23/2009
PAGE
3/5
1 ) Check alignment of plastic holding clips.
2 ) Be sure to pull CHMSL harness completely through deck lid prior to snapping spoiler
into place. Seat the rubber grommet into the sheet metal hole in the deck lid.
3 ) Apply firm downward force at eight clip locations.
4 ) Audible "click" should be heard at each clip location to indicate engagement.
3
RUST
PREVENTATIVE
MAGNET
PROCEDURES:
1 ) Set all drill stops to 1/4" or 6mm depth.
2 ) Drill all 13 locations with 3mm pilot drill first.
3 ) Open all holes to final dimension (REFERENCE MYLAR TEMPLATE).
4 ) Remove all metal chips with vacuum and magnet.
(USE CAUTION NOT TO SCRATCH THE VEHICLE PAINT SURFACE).
5 ) Remove all burrs from holes and apply rust preventative.
7 mm
(17/64")
10 mm
(25/64")
14 mm
(17/32")
8 mm
(5/16")
3 mm
(1/8")
REAR SPOILER ASSEMBLY
PART NUMBER
E721SAJ000 SUBARU OF AMERICA
ISSUE
02
DATE
09/23/2009
PAGE
4/5
5 10 mm
6"
6
1 ) Re-install deck lid carpet panel with the 12 recycled push pins.
2 ) Re-install and correctly seat trunk handle and child safety trunk release when
re-installing liner.
12x
1x TRUNK
HANDLE
CHILD SAFETY
TRUNK RELEASE
SPOILER HIGH MOUNT STOP LAMP
CHMSL HARNESS CONNECTION POINT
T - 6.5 +/- .4 Nm
58 +/- 3 in lbs.
( 4.8 ft. lbs. )
WIRE
TIE
7
REAR SPOILER ASSEMBLY
PART NUMBER
E721SAJ000 SUBARU OF AMERICA
ISSUE
02
DATE
09/23/2009
PAGE
5/5
CHECK THAT SPOILER HIGH MOUNT STOP LAMP PROPERLY
ILLUMINATES WHEN BRAKE PEDAL IS DEPRESSED.

PDF Document reader online

This website is focused on providing document in readable format, online without need to install any type of software on your computer. If you are using thin client, or are not allowed to install document reader of particular type, this application may come in hand for you. Simply upload your document, and Docureader.top will transform it into readable format in a few seconds. Why choose Docureader.top?

  1. Unlimited sharing - you can upload document of any size. If we are able to convert it into readable format, you have it here - saved for later or immediate reading
  2. Cross-platform - no compromised when reading your document. We support most of modern browers without the need of installing any of external plugins. If your device can oper a browser - then you can read any document on it
  3. Simple uploading - no need to register. Just enter your email, title of document and select the file, we do the rest. Once the document is ready for you, you will receive automatic email from us.

Previous 10

Next 10