SVX ALARM 1992

Copy and paste this link to your website, so they can see this document directly without any plugins.



Keywords

with, switch, system, remote, alarm, until, remotes, push, ignition, horn, lights, transmitter, lock, parking, programming, doors, security, When, slowly, will, when, on-off, turn, flash, button, firmly, unlock, turning, signals, flashing

Transcript

SVX ALARM 1992-97
Operating instructions for the standard remote entry and alarm. (from owners manual,
TSBs).
When activated the SVX security system helps protect your car and valuables from intrusion
and theft by sounding the horn, flashing the lights, and interrupting the starter circuit.
Early SVX alarm systems gave off false alarms due to a bad connection in the main Security
switch on the dashboard. If you still have this, be sure to leave it in the 'on' position, and Subaru
recommended turning it on-off every week or so with the car parked and the engine running just
to keep the connection clean.
• Turning the system on and off. With the ignition turned off, press the dashboard on/off
switch marked 'security'. The system is on when the lighted switch flashes, and off when the
light is out.
• Operation with Remote Transmitter.
o When leaving the car, ensure the on/off switch is on and flashing. Close all doors
and trunk
o To arm the system and lock the doors, push the remote transmitter button until the
car signals 'armed' with one beep of the horn and one flash of the lights
o To disarm the system and unlock the doors, push the remote transmitter until the
car horn signals two beeps and two flashes of the lights.
o If the system is armed with the remote it should be disarmed with the remote. If
not, open the door with the key and stop the alarm by turning on the ignition.
• Operation without Remote Transmitter
o To arm the system when leaving the car ensure the on/off switch is on and
flashing, and doors and trunk closed.
o Depress the inside driver's door lock or lock door with the key
o System is automatically armed and locks any unlocked doors 20 seconds after the
last door/trunk closes
o To disarm the system, unlock either door, enter car and tun on ignition
o Audible reminder countdown inside car signals impending alarm activation until
ignition is turned on (20 seconds)
• Turning off the alarm
o Press remote transmitter until the alarm stops or turn on the inanition with the key
• Panic Mode. The alarm may be set off to draw attention to an emergency situation
o To activate: depress remote transmitter for at least 6 seconds. The horn sounds a
warning note after 2 seconds until the full alarm sounds
o To stop the panic alarm. Press and hold the transmitter until the alarm stops or
use the key to turn on the ignition.
• Keyless entry. Even with the security turned off, lock or unlock the doors by depressing
the transmitter. The horn will confirm the action with multiple short but very quiet beeps
To re-program existing remotes if the battery is dead/replaced etc.
The remotes must be re-programmed whenever the battery is dead/disconnected. The parking
lights will flash and the electronic module will click which means it's time to reprogram. Subaru
warns damage to the relay might happen if the remotes are not programmed promptly when the
battery is reconnected.
The antenna for the system is behind the glove box, so point the remotes in that general area
and press the button on the remotes slowly and firmly a total of 5 times. This means if you are
using 1 remote, push it slowly 5x, if you are using 2 remotes push 1 3x and the other 2x, again a
total of 5 times. The parking lights flash each time.
To program NEW remotes
Turn the dashboard Security switch off (no light).
Turn the ignition switch on-off, leave off with key in ignition.
Immediately and -quickly- repeatedly tap the dashboard security switch on-off until the horn
starts to beep. The system will indicate programming mode by the parking lights flashing and
control unit clicking.
I'm told the SVX can be hard to get into programming mode, so be patient and start tapping the
security switch immediately and quickly after turning the ignition switch on-off, and keep tapping
it until the horn beeps.
If you get bored, start again, which you might have to do anyway I'm told. It might take a number
of attempts to get into programming mode.
When in programming mode then:
push the remote 4 times which means....
1 remote: push the remote slowly and firmly 4x
doing 2 remotes? push each remote button slowly anf firmly 2x, for a total of 4x
When done: To complete turn the ignition switch on-off and make sure the parking lights aren't
flashing anymore and remove the key.

PDF Document reader online

This website is focused on providing document in readable format, online without need to install any type of software on your computer. If you are using thin client, or are not allowed to install document reader of particular type, this application may come in hand for you. Simply upload your document, and Docureader.top will transform it into readable format in a few seconds. Why choose Docureader.top?

  1. Unlimited sharing - you can upload document of any size. If we are able to convert it into readable format, you have it here - saved for later or immediate reading
  2. Cross-platform - no compromised when reading your document. We support most of modern browers without the need of installing any of external plugins. If your device can oper a browser - then you can read any document on it
  3. Simple uploading - no need to register. Just enter your email, title of document and select the file, we do the rest. Once the document is ready for you, you will receive automatic email from us.

Previous 10

Next 10